Configuration Guide for Cisco NCS 1001, IOS XR Release 25.x.x

Configure OTDR in automatic mode

Updated: October 14, 2026

Want to summarize with AI?

Use this procedure to configure automatic mode OTDR parameters so the device can run training and measurement phases with default or customized scan values.

Configure automatic mode to have OTDR prepare measurement parameters and run scans through automated training and measurement phases.

Automatic mode provides default values for scan parameters. Adjust values only if the fiber span requires a different measurement behavior.

Procedure

Enter configuration mode.
Example:
```
configure
```
Use the hw-module location command to enter OTDR automatic mode configuration for the slot, port, and direction.
Example:
```
hw-module location 0/RP0/CPU0 slot 3 otdr port 1 direction tx scan auto
```

Configure automatic mode parameters.

See OTDR automatic-mode parameters for parameter descriptions, ranges, and defaults.

Example:


loss-sensitivity 5
loss-relative-threshold 10
reflection-sensitivity -300
reflection-relative-threshold 5
total-loss 300
periodic-scan minutes 40

Commit the configuration and exit configuration mode.
Example:
```
commit
end
```

OTDR automatic mode is configured for the selected port and direction.

OTDR automatic mode parameters

Use these values when configuring OTDR in automatic mode.

Table 1. OTDR automatic mode parameters
Parameter	Description	Range	Default
loss-sensitivity (in 0.1 dB)	Limit under which the loss is not considered a real loss.	4 to 50	6
loss-relative-threshold (in 0.1 dB)	Threshold to compare the OTDR loss value plus the relative loss threshold with the baseline value.	1 to 300	2
reflection-sensitivity (in 0.1 dB)	Limit under which the reflection is not considered a real reflection.	-400 to -140	-300
reflection-relative-threshold (in 0.1 dB)	Threshold to compare the OTDR reflection value plus the relative reflection threshold with the baseline value.	1 to 300	2
total-loss (in 0.1 dB)	Loss from the near-end OTDR port to the far-end OTDR port, including span loss and additional EDFA filter loss.	1 to 500	200
periodic scan (minutes)	Automatically starts OTDR scans and repeats the scan after the periodic scan time elapses.	30 to 600000	30

Note

From Release 7.5.1, the plus sign labels in positive range values are removed in the Cisco NCS 1001 CLI help description.

Start OTDR measurement in automatic mode

Start automatic measurement after the OTDR automatic mode parameters are configured.

The scan continues in the background after the command starts the action.

Procedure

Use the hw-module command to start the OTDR automatic mode scan.

hw-module slot slot-number otdr port port-number direction direction scan auto

Example:

hw-module slot 3 otdr port 1 direction tx scan auto

The system displays the message "Otdr action will continue in the background."

What to do next

To see the measurement status, use the show hw-module slot slot-number otdr status command.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.