Cisco RF Gateway 10 DEPI Configuration

Available Languages

Updated:November 8, 2012

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configuring the Downstream External PHY Interface Feature on the Cisco M-CMTS and EQAM Device [Part 2 of 2]

Configuring the Downstream External PHY Interface Feature on the Cisco EQAM Device, Part 2

This two-part video shows you how to configure the Downstream External PHY Interface (DEPI) feature on the Cisco M-CMTS and Edge Quadrature Amplitude Modulation (EQAM) device using Cisco IOS commands.

Part 2 shows you how to configure DEPI on the Cisco EQAM device. (5 minutes and 50 seconds)
Part 1 shows you how to configure DEPI on the Cisco M-CMTS.

For more details, see the M-CMTS DEPI feature guide.

Viewing this embedded video requires the latest version of Adobe Flash Player with JavaScript enabled.
Get the Flash Player

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products