Skip to content
Skip to search
Skip to footer

Cisco Converged Broadband Routers Hardware Installation Guide

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: December 6, 2017

Chapter: Monitoring the Interface Card in the Cisco cBR Chassis

Monitoring the Interface Card in the Cisco cBR Chassis
Monitoring the Interface Line Cards in the Cisco cBR Chassis using LEDs
Monitoring the Digital Physical Interface Cards in the Cisco cBR Chassis using LEDs

Monitoring the Interface Card in the Cisco cBR Chassis

Monitoring the Interface Line Cards in the Cisco cBR Chassis using LEDs

Table 1. Verifying the LEDs on the Interface Line Cards
LED	Status	Description
STATUS	Off	The line card has not initialized correctly.
	Yellow	The line card has initialized, but HA fault is detected. Possible hardware fault.
	Green	The line card is operational.
PROTECT	Off	The Interface line card is not a Protect card.
	Blue	The Interface line card is configured as a Protect card.
	Green	The Protect card is operational and traffic is flowing.
REPLACE	Off	The Interface line card is operational and does not require replacement.
REPLACE	White	The Interface line card requires replacement.

Monitoring the Digital Physical Interface Cards in the Cisco cBR Chassis using LEDs

cBR CCAP Digital Through PIC

Table 2. Verifying the LEDs
LED	Status	Description
STATUS	Off	The card is not powered up.
STATUS	On	The card is operational.
10GE Link Status	Off	The specific link is down or the optical module is absent.
10GE Link Status	On	The specific link is up.
REPLACE	Off	The card is operational and does not require replacement.
REPLACE	On	The card requires replacement.

cBR-8 2x100G Digital Physical Interface Card

Table 3. Verifying the LEDs
LED	Status	Description
STATUS	Off	The card is not powered up.
STATUS	On	The card is operational.
Link Status	Off	The specific link is down or the optical module is absent.
Link Status	On	Thespecific link is up. QSFP0 port is mapped to LED 0,2,4,6 if it works in 10GE mode and mapped to LED 0 if works in 100GE mode. QSFP1 port is mapped to LED 1,3,5,7 if it works in 10GE mode and mapped to LED 1 if works in 100GE mode.
REPLACE	Off	The card is operational and does not require replacement.
REPLACE	On	The card requires replacement.

Was this Document Helpful?

Feedback

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)