PDF(158.4 KB) View with Adobe Reader on a variety of devices
ePub(213.7 KB) View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
Mobi (Kindle)(123.7 KB) View on Kindle device or Kindle app on multiple devices
Updated:December 13, 2018
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Configure Simple Network Management Protocol (SNMP) Trap Settings on a Switch
The Simple Network Management Protocol (SNMP) is an Internet-standard protocol used to manage devices on IP networks. The SNMP messages are used to inspect and communicate information about managed objects. The Trap message is one of the types of SNMP messages which are generated to report system events.
The Cisco Small Business Series Switches function as an SNMP agent and reports system events to trap receivers, also known as Notification Recipients, with the traps defined in the supported Management Information Base (MIBs). Trap-directed notification can greatly improve a network because it removes the need for frivolous SNMP requests.
This article provides instructions on how to configure the system time settings on your switch.
1.4.7.05 — Sx300, Sx500
2.2.8.04 — Sx250, Sx350, SG350X, Sx550X
Configure SNMP Trap Settings on your Switch
The Trap Settings page of the web-based utility of the switch allows you to configure whether SNMP notifications are sent from the device, and for which applicable cases. Follow the steps below to configure the SNMP trap settings on your switch.
Note: To know how to configure the SNMP Notification Recipients SNMPv1, SNMPv2, or SNMPv3, click here. For instructions on how to configure SNMP notification filter on a switch, click here.
Step 1. Log in to the web-based utility of your switch then choose Advanced in the Display Mode drop-down list.
Note: In this example, SG350X-48MP switch is used.
Note: If you have an Sx300 or Sx500 Series switch, skip to Step 2.