The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
When you configure Network Address Translation (NAT) on a Cisco IOS® router, multicast sources and receivers, or Protocol Independent Multicast (PIM) entities, such as Rendezvous Points (RPs) or RP mapping agents, work on either side of the NAT router without additional configuration commands.
You must fully enable multicast on all the routers (inside, outside, and the NAT router itself).
Readers of this document should have knowledge of these topics:
The feature described in this document was introduced in Cisco IOS Software Release 12.0(1)T.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Data packet source address translation.
PIM control packet (PIM payload) address translation, including Auto-RP and PIM Version 2 bootstrap router (BSR).
The mstat, mrinfo, and mtrace command requests and responses.
SDR advertisement or application payload.
With the above translations, PIM works in an enterprise domain even if part of the domain is behind NAT. All sources and receivers behind the NAT router can send and receive packets to the rest of the PIM cloud, and take advantage of the RP/RP mapping agent on either side of the cloud.
Terminate tunnels on the NAT router using the ip nat inside/outside command. Tunnels cannot run through the NAT router with end points on either side.
Addresses in Real-Time Transport Protocol (RTP), RTP Control Protocol (RTCP), or other application payloads are not translated.
This feature does not translate destination group addresses.