E&M Cable Pinouts Connecting Cisco 1750/2600/3600 E&M VIC to Lucent PBX G3R E&M Trunk

Available Languages

Updated:February 2, 2006
Document ID:8635

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes the E&M Cable Pinouts connecting a Cisco 1750/2600/3600 E&M voice interface card (VIC) to a Lucent PBX G3R E&M Trunk.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

For more information on document conventions, see the Cisco Technical Tips Conventions.

Pinout

Note: Lucent G3R PBX ty1-stan and ty5 interoperate with Cisco 1750/2600/3600 E&M VIC.

Type 1 & 5; 4-wires; router to PBX -----Lucent-----
Router  Pins 	  PBX
        1 --
   M    2 -- 6    M
   R    3 -- 4    TA
  R1    4 -- 1    RA
  T1    5 -- 2    RB
   T    6 -- 5    TB
   E    7 -- 3    E
        8 --

Related Information

Was this Document Helpful?

FeedbackFeedback

Contact Cisco