- Preface
- Overview of Cisco Catalyst IW9167E and IW9165 Access Points
- Device Initial Configuration in Provisioning Mode
- Upgrade the Device using GUI
- Upgrade the Device using TFTP
- Configuring URWB Operation Mode
- Configuring URWB Radio Mode
- Configuring Radio Antenna Settings
- Configuring Wired Interface
- Configure and validate radio channel and bandwidth
- Configuring and Validating High Efficiency (802.11 ax)
- Configuring Guard Interval for HE (High Efficiency)
- Configuring and Validating SNMP
- Multicast
- Quality of Service
- Frequency Scan
- Configuring and Validating Key Controller (Wireless Security)
- Fixed domains and country codes (ROW)
- Configuring and Validating of Point-to-Point Relay Topology
- Configure and Validate Fluidmax Topology
- Configuring and Validating Mixed Mode (Fixed infrastructure + Fluidity) Topology
- Configure and Validate Fast Failover
- Configuring Indoor Deployment
- Smart Licensing
- Configuring Layer 2 Mesh Transparency
- Configuring Multipath Operation
- Configuring URWB Telemetry Protocol
- Configuring IW Monitor Management
- LED Pattern for Catalysts IW9167 and IW9165
Cisco Ultra-Reliable Wireless Backhaul for Catalyst IW Access Points, Software Configuration Guide, Release 17.13.1
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- July 31, 2025
Feedback