Cisco UCS Manager System Monitoring Guide Using the CLI, Release 6.0

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: September 2, 2025

System Monitoring and Debugging

Load Debug Plugin

The load-debug-plugin command is intended for use by Technical Assistance Center (TAC) personnel. This command enables the loading of debug plugins, which provide enhanced visibility and diagnostic capabilities during critical fault and error conditions in Cisco UCS Manager. It is applicable only for Cisco UCS 6300 Series Fabric Interconnects and lower versions.

Procedure


Command or Action	Purpose
UCS-A# load debug-plugin	Loads the debug-plugin image. This debug plugin image is copied by TAC and loaded for the purpose of monitoring and debugging.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)