- Preface
-
- Configuring the Cisco Application Control Engine
- Configuring the Cisco TelePresence Multipoint Switch
- Configuring the Cisco Router with IVR
- Configuring Cisco Unified Communications Manager
- Configuring Cisco TelePresence Manager
- Configuring Cisco Session Border Controllers
- Configuring Cisco TelePresence MSE 8000 Series
- Configuring Internet Group Management Protocol for Multicast Support
- Glossary
Endpoint Capacity
Three factors determine how many segments the Cisco TelePresence Exchange System reserves for an endpoint: the bridge type that handles the call (Cisco TelePresence Multipoint Switch or Cisco TelePresence MSE 8000 Series), the type of call (dial in or dial out), and the number of endpoint screens.
Table B-1 describes the number of segments that the Cisco TelePresence Exchange System reserves for a Meet-Me call given a number of variables.
Note The minimize capacity functionality is available only in Cisco TelePresence Exchange System Release 1.0(3) and later.
Please note the following bridge limitations:
•Dial out calls are not supported on Cisco TelePresence System endpoints.
•Guest dial out to three-screen H.323 endpoints is not supported.
•The Cisco TelePresence System endpoints and three-screen H.323 endpoints are not supported on the Cisco TelePresence MCU MSE 8510.