Installation Worksheets

Revised June 30, 2011

Complete these worksheets before you install the software on the Cisco TelePresence Exchange System database, administration, and call engine servers. For details and requirements, see the "Gathering Required Information Before Installation" section on page 4-6.

Table A-1 Worksheet for Cisco TelePresence Exchange System Servers 

Node
Hostname
IP Address
Subnet Mask
Default
Gateway
Administrator Username
Password

Database—shared virtual1

     

—

—

—

Database—primary

           

Database—secondary

           

Database—primary IMM2

—

         

Database—secondary IMM

—

         

Engine 1

           

Engine 1—IMM (optional)

—

         

Engine 2

           

Engine 2—IMM (optional)

—

         

Admin 1

           

Admin 1—IMM (optional)

—

         

Admin 2

           

Admin 2—IMM (optional)

—

         

Security password to authenticate data requests between the database server and the other servers3

 

1 The virtual hostname and virtual IP (VIP) address are shared by both the primary and secondary database servers.

2 IMM = integrated management module. The IMM configuration is required to provide active/standby redundancy on the database servers. For the call engine and administration servers, you need to configure the IMM only if you want remote control.

3 The security password must be identical for all nodes in the server cluster. After you set the security password on a server, you cannot change it without reinstalling the server.


Table A-2 Worksheet for Other Solution Components 

Component
Information
Value

SIP load balancer (ACE1 )

VIP2 address

 

Port3

 

DNS4 (optional)

IP address of primary DNS server

 

IP address of secondary DNS server (optional)

 

Domain name5

 

NTP6

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

1 ACE = Cisco Application Control Engine.

2 VIP = virtual IP address.

3 Cisco recommends that you use the default port 5060.

4 DNS = Domain Name System.

5 Example domain names: cisco.com, example.net.

6 NTP = network time protocol. Only one NTP entry is required, but Cisco recommends that you have at least three clocking sources.


Table A-3 Worksheet for Generating LSCs1 for the Cisco TelePresence Exchange System Servers 

Node
Organization
Unit
Location
State
Country

Database—primary

         

Database—secondary

         

Engine 1

         

Engine 2

         

Admin 1

         

Admin 2

         

1 LSC = locally significant certificate