Migrating FDM-managed device to Cisco Secure Firewall Threat Defense Using Firewall Migration Manager

PDF

Migrating FDM-managed device to Cisco Secure Firewall Threat Defense Using Firewall Migration Manager

Connect to the FDM-managed device from Firewall Migration Manager

Want to summarize with AI?

Log in

Configure FMM to connect to an FDM-managed device and migrate necessary configuration settings.


Before you begin

Firewall Migration Manager can connect to an FDM-managed device that you want to migrate and extract the required configuration information. Live connect to FDM-managed device is supported for all three use cases.

  • Download and open the Firewall Migration Manager.

  • Select the use case you want to carry out for FDM-managed device to management center migration.

  • Obtain the management IP address, administrator credentials of the device manager.

Procedure

  1. On the Source Configuration screen, in the Connect to Firewall section, click Connect to connect to the FDM-managed device that you want to migrate

  2. In the Connect to Firewall section, enter the following information:

    1. In the IP Address/Hostname/FQDN field, enter the management IP address or hostname of the FDM. Click Login.

    2. In the Username, Password fields enter the appropriate administrator login credentials.

    3. Click Connect & extract configuration.

    When Firewall Migration Manager connects to the FDM-managed device, a series of compliance checks are performed on the FDM-managed device before proceeding with the migration. These checks are covered in the pre-requisites and best practices section. If the checks are successful, the migration proceeds to the next step.

    Firewall Migration Manager connects to the FDM-managed device, and once the compliance check succeeds, the tool starts extracting configuration information. When the extraction completes successfully, the parsed summary page is displayed.

    The Parsed Summary section displays the parsing status.

  3. Review the summary of the elements that Firewall Migration Manager detected and parsed, from the FDM-managed device.

  4. Click Next, to select the target parameters.

What to do next

Connect to Firewall Management Center and select a target device