Before You Begin

Obtain the serial number of each Cisco Catalyst 8000V device that you are configuring. To do so, go to Cisco Software Central and click Manage Devices under Network Plug and Play in the Smart Licensing area.

Configuration Procedures

The following table describes the procedures for configuring a Cisco Catalyst 8000V device as a cloud gateway in various scenarios. For each scenario, the table provides the general steps, and references to more detailed information. See the scenario that applies to your requirements.

Configure a Cloud Gateway in the Cisco Catalyst SD-WAN Portal

1. Log in to the Cisco Catalyst SD-WAN Portal with administrator credentials.

2. Click the fabric for which you want to configure a cloud gateway.

3. From the Actions drop-down menu, choose Add Cloud Gateways.

4. Configure the fields that the following table describes.

   Note	The Cisco Catalyst SD-WAN Portal does not save the usernames and passwords that you enter in these fields.

   Field	Description
   vManage Admin Credentials
   Username	Enter your Cisco SD-WAN Manager administrator username.
   Password	Enter your Cisco SD-WAN Manager administrator password.
   Smart Account Admin Credentials
   Username	Enter your Cisco Smart Account administrator username.
   Password	Enter your Cisco Smart Account administrator password.
   Cloud Gateway Serials
   Serial	The number of Serial fields that appear matches the number of regions in your fabric. In each field, enter the serial number of the Cisco 8000V to serve as a cloud gateway. Each serial number must be unique.
   Custom IPs
   System IPs	The number of System IPs fields that appear matches the number of regions in your fabric. (Optional) In each field, enter an IP address to configure a system interface for the cloud gateway that you are adding. A system interface IP address is a persistent address that identifies the device. It is similar to a router ID on a regular router, which is the address that is used to identify the router from which packets originated. Specify a system IP address as an IPv4 address in decimal four-part dotted notation. Specify just the address; the prefix length (/32) is implicit. A system IP address can be any IPv4 address except for 0.0.0.0/8, 127.0.0.0/8, and 224.0.0.0/4, and 240.0.0.0/4 and later. If you do not specify a system IP address, the Cisco Catalyst SD-WAN Portal assigns a system random IP address, which may be a duplicate of the IP address of another device. To ensure that a cloud gateway is provisioned without creating a conflict in the fabric, ensure that an IP address that you enter is unused in the existing fabric.
   Enable Webhook via Cloud Gateway	This option applies only to a Dedicated fabric for which AWS is the cloud provider. Check this check box to enable Cisco SD-WAN Manager to route webhook messages from CCisco SD-WAN Manager through a cloud gateway Enabling this option is useful when your webhook server is hosted in your private network and no internet traffic is forwarded to this server. When this option is enabled, a connection is provisioned between your SD-WAN fabric and your private network. After enabling this option, add an entry to the routing table on the Cisco SD-WAN Manager server to forward network traffic to the webhook server through the cloud gateway. For instructions, see the email that you receive after the cloud gateway is provisioned.

5. Click Submit.

Open a Support Case for a Fabric Update

To open a support case for a fabric update, go to Cisco Support Case Manager, log in with your Cisco credentials, and click Open New Case.