NTP-G51 Verify DWDM Node Turn Up
Purpose |
This procedure verifies that each node is ready for DWDM network turn-up before adding nodes to a network. This procedure applies to all ROADM, OADM, and line-amplifier nodes. |
Tools/Equipment |
Network plan provided by your network administrator |
Prerequisite Procedures |
|
Required/As Needed |
Required |
Onsite/Remote |
Onsite or remote |
Security Level |
Provisioning or higher |
Procedure
Step 1 |
Click the Alarms tab.
|
Step 2 |
Verify that the software version shown in the node view (single-shelf mode) or multishelf view (multishelf mode) status area matches the version required by your network. (The status area is located to the left of the shelf graphic.) If the software is not the correct version, perform one of the following procedures:
|
Step 3 |
Click the NTP-G80 Change Node Management Information procedure. tabs. Verify that all general node information settings are correct according to documentation provided by the network administrator. If not, see the |
Step 4 |
Click the NTP-G81 Change CTC Network Access procedure. tabs. Ensure that the IP settings and other Cisco Transport Controller (CTC) network access information is correct according to documentation provided by the network administrator. If not, see the |
Step 5 |
Click the NTP-G83 Modify or Delete Card Protection Settings procedure. tabs. Verify that all required protection groups have been created according to documentation provided by the network administrator. If not, see the NTP-G33 Create a Y-Cable Protection Group” procedure or the |
Step 6 |
Click the NTP-G88 Modify Users and Change Security procedure. tabs. Verify that all users have been created and that their security levels are correct according to documentation provided by the network administrator. If not, see the |
Step 7 |
If Simple Network Management Protocol (SNMP) is provisioned on the node, click the NTP-G89 Change SNMP Settings procedure. tabs. Verify that all SNMP settings are correct according to documentation provided by the network administrator. If not, see the |
Step 8 |
Repeat this procedure at each node in the network. Stop. You have completed this procedure. |