Cisco Nexus 9000 Series NX-OS IP SLAs Configuration Guide, Release 10.6(x)

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: August 14, 2025

New and Changed Information

This table summarizes the new and changed features for the Cisco Nexus 9000 Series NX-OS IP SLAs Configuration Guide, Release 10.6(x) and where they are documented.

Table 1. New and Changed Features
Feature	Description	Changed in Release	Where Documented
IPv6 Support for UDP Jitter Operations	Beginning with Cisco NX-OS Release 10.6(1), IPv6 is supported for UDP jitter operations. You can now configure IPv6 addresses for both the destination and source in UDP jitter operations, as well as enable IPv6-based responders to handle these operations.	10.6(1)F	Guidelines and Limitations for UDP Jitter Operations Configuring and Scheduling a UDP Jitter Operation on the Source Device

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)