Replace Node in a CSP Cluster if Storage Virtualization is Enabled

Available Languages

Download Options

  • PDF     (33.6 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (103.1 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (96.8 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:December 8, 2020
Document ID:215555

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

    Introduction

    This document describes the procedure to replace a node in a Cloud Service Platform (CSP) cluster if storage virtualization is enabled.

    Prerequisites

    Requirements

    Cisco recommends that you have knowledge of Cisco CSP Software.

    Components Used

    The information in this document is based on these software and hardware versions:

    • CSP 2100
    • UCS C Series - Cisco Integrated Management Controller (CIMC)
    • Keyboard Video Mouse (KVM) to Map Virtual Media
    • CSP 2100 International Organization for Standardization (ISO) 

    The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.

    Problem

    If a CSP server in a cluster with storage virtualization enabled needs to be replaced, follow the procedure to remove that server from the cluster and add the new server into the current cluster.

    Make sure storage virtualization is enabled in the setup on the Cluster Advance Configuration tab, verify Enable Storage Network is set to true.

    Solution

    Contact Cisco TAC to swap a replacement node into a CSP cluster with Enable Storage Network set to true, TAC uses internal documentation titled Replace Node in a CSP Cluster if Storage Virtualization is Enabled.

    Related Information

    TAC Authored

    Contributed by Cisco Engineers

    • Dhanashree Gosavi
      Cisco TAC Engineer
    • James Richardson
      Cisco TAC Engineer

    Was this Document Helpful?

    FeedbackFeedback

    Contact Cisco

    This Document Applies to These Products