How can I Enable or Disable AI Assistant in Cisco License On-Prem(CLP) deployment?

 
Updated November 17, 2026
PDF
Is this helpful? Feedback

Introduction 

This document provides a step-by-step guide for enabling or disabling AI assistant within the Cisco License On-Prem (CLP) portal. 

 

Prerequisites 

Before you start, ensure that you have the following: 

  • A Cisco Smart Account. 
  • A valid Cisco.com (CCO) User ID and password with access to the relevant Smart or Virtual Account. 
  • Admin Access to Cisco License On-Prem (CLP) Portal. 

 

Steps 


Disable AI Assistant  

Step 1: Access the Cisco License On-Prem (CLP) portal at: https://<IP_Address>:8443/admin/#/mainview. 

Step 2: Navigate to the Admin workspace from the left-hand menu. 

Step 3: Click the AI Configuration tab from the left-hand menu. 

Step 4: Locate the Enable AI Assistant toggle and switch it to Off. 

note-icon

Note: The AI Assistant is enabled by default in CLP.

 Step 5: Click Apply, then Disable AI Assistant- the confirmation pop-up appears; read and click Apply again. 
Step Result: The AI Assistant will be disabled. 

 

Enable AI Assistant 
Step 1:In the AI Configuration tab under the Admin workspace, locate the Enable AI Assistant toggle and switch it on.

note-icon

Note: Review the caution messages and disclosure information before enabling.

Step 2: Click Apply. 
Step Result: The AI Assistant will be enabled. 

note-icon

Note: You can also enable or disable the AI Assistant directly from the AI Assistant widget in the upper-right corner of the CLP portal. Hover over the AI Assistant icon to access the toggle and perform the desired action.

 

Troubleshooting 

For External Customer/Partner Use Only: Follow these instructions to resolve your issue. If you need further assistance, please initiate a request for License Support via Cisco Support Case Manager.