Hard Plug Loopback Test

Available Languages

Updated:October 23, 2018
Document ID:9343

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document provides a flowchart for the hard plug loopback test.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Flowchart

Click the command boxes in the diagram for more information.

t1_flchrt_loop.gif

Related Information

Loopback Plug Enter these commands Prepare for the Extended Ping Test Prepare for the Extended Ping Test Perform Extended Ping Tests Perform Extended Ping Tests Perform Extended Ping Tests Perform Extended Ping Tests

Revision History

Revision Publish Date Comments
1.0
23-Oct-2018
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products