Client Exclusion Timeout
You can configure a timeout for disabled clients. Clients who fail to authenticate three times when attempting to associate are automatically disabled from further association attempts. After the timeout period expires, the client is allowed to retry authentication until it associates or fails authentication and is excluded again.
You can also enable or disable client exclusion on a per-WLAN basis. If enabled, you can configure the duration of the exclusion period. The activities that trigger client exclusion are configured globally.
Configuring Client Exclusion Timeout (CLI)
Configure the timeout for disabled clients by entering this command: command:
config wlan exclusionlist wlan-id timeout
The valid timeout range is between 1 and 2147483647 seconds. A value of 0 permanently disables the client.
Verify the current timeout by entering this command: