Configuring Access Points with Dual-Band Radios

Configuring Access Points with Dual-Band Radios (GUI)

Procedure

Step 1

Choose Wireless > Access Points > Radios > Dual-Band Radios to open the Dual-Band Radios page.

Step 2

Hover your cursor over the blue drop-down arrow of the AP and click Configure.

Step 3

Configure the Admin Status.
Step 4

Configure CleanAir Admin Status as one of the following:

  • Enable
  • Disable
  • 5 GHz Only
  • 2.4 GHz Only
Step 5

Click Apply.

Step 6

Click Save Configuration.

What to do next

You can monitor the access points with dual-band radios by navigating to Monitor > Access Points > Radios > Dual-Band Radios.

Configuring Access Points with Dual-Band Radios (CLI)

Procedure

  • Configure an access point with dual-band radios by entering this command:

    config 802.11-abgn {enable | disable} ap-name

  • Configure the CleanAir features for an access point with dual-band radios by entering this command:

    config 802.11-abgn cleanair {enable | disable} ap-name band 2.4-or-5-GHz