Table Of Contents
Configuring MIB2 System Group in Cisco Unified Serviceability
Configuring the MIB2 System Group
Configuring MIB2 System Group in Cisco Unified Serviceability
May 19, 2009
Cisco Unified Serviceability allows you to configure the system contact and system location objects for the MIB-II system group. For example, you could enter Administrator, 555-121-6633, for the system contact and San Jose, Bldg 23, Second floor, for the system location.
•
Configuring the MIB2 System Group
Configuring the MIB2 System Group
You can configure a system contact and system location for the MIB-II system group.
Tip This procedure supports SNMP v1, v2c, and v3 configuration.
Procedure
Step 1 Select Snmp > SystemGroup > MIB2 System Group.
Step 2 Configure the MIB2 System Group settings, as described in the table below.
Table 15-1 MIB2 System Group Configuration Settings
|
Field
|
Description
|
Server |
From the list box, select the server for which you want to configure contacts; then, click Go. |
System Contact |
In the field, enter a person to notify when problems occur. |
System Location |
In the field, enter the location of the person that is identified as the system contact. |
Apply To All Nodes |
Check to apply the system configuration to all of the nodes in the cluster. |
Step 3 Click Save. A message indicates that changes will not take effect until you restart the SNMP master agent.
Step 4 Perform one of the following actions:
a. Click OK to restart the SNMP master agent service.
b. Click Cancel to continue the configuration without restarting the SNMP master agent.
Step 5 Perform one of the following actions:
a. Click Clear All to clear the System Contact and System Location fields.
b. Click Clear All and Save to delete the system configuration.
Feedback