Configuring Platform Event Filters

This chapter includes the following sections:

Platform Event Filters

Configuring Platform Event Filters

You can configure actions and alerts for the following platform event filters:

Procedure

  Command or Action Purpose

Step 1

Server# scope fault

Enters the fault command mode.

Step 2

Server /fault # scope pef id

Enters the platform event filter command mode for the specified event.

See the Platform Event Filter table for event ID numbers.

Step 3

Server /fault/pef # set action {none | reboot | power-cycle | power-off}

Selects the desired system action when this event occurs. The action can be one of the following:

  • none —No system action is taken.

  • reboot —The server is rebooted.

  • power-cycle —The server is power cycled.

  • power-off —The server is powered off.

Step 4

Server /fault/pef # commit

Commits the transaction to the system configuration.

Example

This example configures the platform event alert for an event: 

Server# scope fault
Server /fault # scope pef 5
Server /fault/pef # set action reboot
Server /fault/pef *# commit
Server /fault/pef # show
Platform Event Filter Event                       Action              
--------------------- --------------------------- -----------  
5                    Processor Assert Filter         reboot                  

Server /fault/pef #