F Commands

This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) commands that begin with F.

feature vrrp

To enable the Virtual Router Redundancy Protocol (VRRP), use the feature vrrp command. To disable VRRP, use the no form of this command.

feature vrrp

no feature vrrp

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

Global configuration mode

Command History

Release
Modified

6.0(2)N1(1)

This command was introduced.


Usage Guidelines

You must enable the VRRP feature before you can configure VRRP.

This command does not require a license.

Note Make sure the LAN Base Services license is installed on the switch to enable Layer 3 interfaces.

Examples

This example shows how to enable the VRRP feature: 

switch# configure terminal

switch(config)# feature vrrp 

switch(config)# 

 
   
 
    
   
 This example shows how to disable the VRRP feature: 
 
    
   
 
    
switch# configure terminal

 
   
 
    
   
 
    
switch(config)# no feature vrrp 

 
   
 
    
   
 
    
switch(config)# 

 
   
 
    
   
 Related Commands
 
   
 
    
 
      
      
      
 
        
        

          Command 
        
 		 
        
        

          Description 
        
 		 
      
 
      
 
       
 clear vrrp 
 		 
       
 Clears all the software counters for the specified virtual router. 
 		 
      
 
      
 
       
 show feature 
 		 
       
 Displays the status of features on a switch. 
 		 
      
 
      
 
       
 show vrrp 
 		 
       
 Displays VRRP configuration information. 
 		 
      
 
      
 
       
 vrrp 
 		 
       
 Configures a VRRP group on an interface.