The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Border Gateway Protocol (BGP) commands that begin with F.
To enable the Border Gateway Protocol (BGP), use the feature bgp command. To disable BGP, use the no form of this command.
feature bgp
no feature bgp
This command has no arguments or keywords.
Disabled
Global configuration mode
|
|
---|---|
6.0(2)N1(1) |
This command was introduced. |
You must enable the BGP feature before you can configure BGP.
This command requires the LAN Enterprise Services license.
This example shows how to enable a BGP configuration:
switch# configure terminal
switch(config)# feature bgp
switch(config)#
This example shows how to disable the BGP feature:
switch# configure terminal
switch(config)# no feature bgp
switch(config)#
|
|
---|---|
router bgp |
Creates a BGP instance. |
show bgp |
Displays BGP configuration information. |
show feature |
Displays the status of features on a switch. |