F Commands

This chapter describes the Cisco NX-OS Routing Information Protocol (RIP) commands that begin with F.

feature rip

To enable the Routing Information Protocol (RIP), use the feature rip command. To disable RIP, use the no form of this command.

feature rip

no feature rip

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

Global configuration mode

Command History

Release
Modified

6.0(2)N1(1)

This command was introduced.


Usage Guidelines

You must enable the RIP feature before you can configure RIP.

This command does not require a license.

Note Make sure the LAN Base Services license is installed on the switch to enable Layer 3 interfaces.

Examples

This example shows how to enable the RIP feature: 

switch# configure terminal

switch(config)# feature rip

switch(config)#

 
   
 
    
   
 This example shows how to disable the RIP feature: 
 
    
   
 
    
switch# configure terminal

 
   
 
    
   
 
    
switch(config)# no feature rip

 
   
 
    
   
 
    
switch(config)#

 
   
 
    
   
 
    
 
   
 
    
   
 Related Commands
 
   
 
    
 
      
      
      
 
        
        

          Command 
        
 		 
        
        

          Description 
        
 		 
      
 
      
 
       
 router rip 
 		 
       
 Creates a RIP instance. 
 		 
      
 
      
 
       
 show feature 
 		 
       
 Displays the status of features on a switch. 
 		 
      
 
      
 
       
 show rip 
 		 
       
 Displays RIP configuration information.