Advanced Configuration and Modification of the Management Ethernet Interface
This module describes the configuration of Management Ethernet interfaces.
Before you can use Telnet to access the router through the LAN IP address, you must set up a Management Ethernet interface and enable Telnet servers, as described in the Configuring General Router Features module of the . This module describes how to modify the default configuration of the Management Ethernet interface after it has been configured, as described in Getting Started Guide.
Note |
Forwarding between physical layer interface modules (PLIM) ports and Management Ethernet interface ports is disabled by default. To enable forwarding between PLIM ports and Management Ethernet interface ports, use the rp mgmtethernet forwarding command. |
Note |
Although the Management Ethernet interfaces on the system are present by default, the user must configure these interfaces to use them for accessing the router, using protocols and applications such as Simple Network Management Protocol (SNMP), Common Object Request Broker Architecture (CORBA), HTTP, extensible markup language (XML), TFTP, Telnet, and command-line interface (CLI). |
Feature History for Configuring Management Ethernet Interfaces
Release |
Modification |
Release 2.0 |
This feature was introduced on theCisco CRS-1 Router. |
Release 3.2 |
This feature was first supported on the.Cisco XR 12000 Series Router |
Release 3.3.0 |
Manual configuration of the Management Ethernet interface is the only option. The initial prompts that originally walked the user through Management Ethernet interface configuration upon software installation were removed. |