Cisco 5-in-1 Vehicle Mount and Fixed Infrastructure Antenna (ANT-5-4G2WL2G1-O) Transportation omnidirectional 5-element antenna for 2G, 3G, 4G cellular, GPS, and dual-band WiFi 2.4 GHz and 5 GHz.
Antenna has 2 ports for 2G, 3G, 4G, 2 ports for dual band 2.4 / 5.8 GHz WiFi, and 1 port for GPS.
|
2 x 4G LTE, TNC(m)
2 x 2.4/5 GHz WiFi, RPTNC(plug)
1 x GPS SMA(m)
|
4G LTE 698-960, 1448-1511, 1710-2400, 2500-2700 MHz.
2.4 dBi typical, 2.9 dBi max 698-960 MHz
4.2 dBi typical, 4.8 dBi max 1448-1511 MHz
4.9 dBi typical, 6.5 dBi max 1710-2700 MHz
|
Good fit for IR829.
Can be used with other products such as IR809 or IR807, but has extra WiFi elements not required for those products.
Instead consider ANT-3-4G2G1-O for products without WiFi.
|
Cisco Cellular and GPS 3-in-1 Vehicle Mount and Fixed Infrastructure Antenna (ANT-3-4G2G1-O) Cellular 3-in-1 Two port 2G, 3G, 4G and 1 port GPS Vehicle Mount and Fixed Infrastructure Antenna, with three ports.
|
2 x 4G LTE, TNC(m)
1 x GPS SMA(m)
|
4G LTE 698-960, 1448-1511, 1710-2400, 2500-2700 MHz
2.6 dBi typical, 3.8 dBi max 698-960 MHz
3.8 dBi typical, 4.3 dBi max 1448-1551 MHz
4.6 dBi typical, 5.5 dBi max 1710-2700 MHz
|
IR807, IR809, and IR829
IR1101 with P-LTE cellular module
C819HG-LTE and C819HG-4G
CGM-3G and CGM-4G modules with CGR1120 router
CGR1120 use case requires adapters
|
Cisco Dual LTE-Single GPS Multi-band Antenna Installation Guide (4G-LTE-ANTM-O-3-B) Cellular 3-in-1 Two port for 2G, 3G, 4G LTE and one port for GPS
Integrated indoor and outdoor Antenna with three ports.
|
2 x 4G LTE, TNC(m)
1 x GPS SMA(f)
|
4G LTE 698-960, 1710-2700 MHz
2.5 dBi typical 698-960 MHz
2.5 dBi typical 1710-2700 MHz
|
IR1101 with P-LTE cellular module
|
Cisco Cellular 2-in-1 Vehicle Mount and Fixed Infrastructure Antenna (ANT-2-4G2-O) Two port 2G, 3G, and 4G antenna with two elements.
This dual port LTE antenna does not have an active GPS antenna (compared to ANT-3-4G2G1-O which does), and is useful for
cases when there is no GPS required, or when GPS is connected to a completely separate GPS antenna.
|
2 x 4G LTE, TNC(m)
|
4G LTE: 698-960,1448-1511,1710-2400,2500-2700 MHz
2.6 dBi typical, 3.8 dBi max 698-960 MHz
3.8 dBi typical, 4.3 dBi max 1448-1511 MHz
4.6 dBi typical, 5.5 dBi max 1710-2700 MHz
No GPS element and no WiFi.
|
IR807, IR809, and IR829
IR1101 with P-LTE cellular module
C819HG-LTE and C819HG-4G
CGM-3G and CGM-4G modules with CGR1120 router.
CGR1120 use case requires coax adapters
|
Cisco Outdoor Omnidirectional Antenna for 2G/3G/4G Cellular (ANT-4G-OMNI-OUT-N) Outdoor Omnidirectional Antenna for 2G/3G/4G Cellular antenna is designed to cover domestic LTE700/Cellular/PCS/AWS/MDS,
WiMAX 2300/2500, and GSM900/GSM1800/UMTS/LTE2600 bands.
|
N-Type female
|
698 to 862 MHz
824 to 894MHz
880 to 960MHz
1710 to 1880Mhz
1850 to 1990MHz
1920 to 2170MHz
2300 to 2400MHz
2400 to 2500MHz
2500 to 2690MHz
3400 to 3800 MHz
1.5 dBi (698 to 960MHz)
3.5 dBi (1710 to 2690MHz)
5.2 dBi (3400 to 3800MHz)
|
IR807, IR809, and IR829
IR1101 with P-LTE cellular module
C819HG-LTE and C819HG-4G
CGM-3G and CGM-4G modules with CGR1120 and CGR1240.
In most cases adapters or cables are required.
|
Cisco Multiband Panel Outdoor 4G MIMO Antenna (ANT-4G-PNL-OUT-N) Multiband Panel Outdoor 4G MIMO dual-port antenna designed to cover cellular 4G bands.
|
Dual type N female direct connector
|
698-960 MHz 8.0-10.0 dBi
1710-2170 MHz 6.0-8.5 dBi
2200-2400 MHz 6.5-9.5 dBi
2500-2700 MHz 8.5-9.5 dBi
Antenna is not designed to operate in 1448-1511 MHz Japan band. Does not have high gain.
|
IR807, IR809, and IR829
IR1101 with P-LTE cellular module
C819HG-LTE and C819HG-4G
CGM-3G and CGM-4G modules with CGR1120 and CGR1240.
In most cases adapters or cables are required.
|
Cisco Multiband Indoor 4G Volcano Antenna (ANT-4G-CM-IN-TNC) Multiband Indoor 4G Ceiling-mount Volcano Antenna.
|
1 x TNC (m)
|
1 dBi 698-960 MHz
3 dBi 1710-2700 MHz
|
IR807, IR809, and IR829
C819HG-LTE and C819HG-4G
CGM-3G and CGM-4G modules with CGR1120 and CGR1240.
For CGM / CGR use case adapters are required
|
ANT-MP2-I-OUT-M and ANT-MP2-I-O-SS-M Antenna and Cable Kits For 4G cellular use you need the ANT-MP2-I-O-SS-M antenna kit. The kit has qty 2 antennas and cables needed for Main and
Aux cellular ports.
ANT-MP2-I-OUT-M is for 915 MHz WPAN, and only has a single antenna and cable in the kit.
Designed for direct mounting on the CGR1240 and has an MCX connector.
|
MCX jack
|
0.9 dBi typical, 2.8 dBi max 698-960 MHz
3.0 dBi typical, 4.3 dBi max 1710-2700 MHz
4.0 dBi typical, 5.0 dBi max 2300-2700 MHz
Note
|
Degraded performance in Japan 1448-1511 MHz band.
|
|
ANT-MP2-I-O-SS-M kit is compatible with CGM-3G and CGM-4G in CGR1240 chassis.
The antennas are not mechanically compatible with the CGR1120 chassis.
|
Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Integrated 4G Low-profile Outdoor Saucer Antenna.
|
15 foot LMR 195 cable with TNC(m)
|
0.8 dBi 698-960 MHz
0.5 dBi 1448-1511 MHz
0.2 dBi 1710-2700 MHz
|
IR807, IR809, and IR829
C819HG-LTE and C819HG-4G
CGM-3G and CGM-4G modules with CGR1120 and CGR1240.
For CGM / CGR use case adapters are required.
|
Cisco 4G/3G Omnidirectional Dipole Antenna (4G-LTE-ANTM-D) LTE-ANTM-D is a high performance indoor antenna for use in the 698-960, 1448-1511 and 1710-2690 MHz frequency bands.
LTE-ANTM-D antennas have high standalone efficiency, and maintain high efficiency when directly installed on front plate
of a small or medium size Cisco router. However, depending on chassis size and a variety of other electromagnetic considerations,
installing the antenna directly on the chassis is not always recommended.
|
1 x TNC(m)
|
2 dBi, 698-960 MHz
2.8 dBi, 1447-1511 MHz
3.7 dBi, 1710-2690 MHz
|
IR807, IR809, and IR829
C819HG-LTE and C819HG-4G
CGM-3G and CGM-4G modules in CGR1120 (with additional adapters & cable accessories)
|
Cisco 4G LTEA, 4G LTE, and 3G Omnidirectional Dipole Antenna (LTE-ANTM-SMA-D) LTE-ANTM-SMA-D is a high performance indoor antenna for use in the 698-960, 1448-1511 and 1710-2690 MHz frequency bands.
LTE-ANTM-SMA-D antennas have high standalone efficiency, and maintain high efficiency when directly installed on front plate
of a small or medium size Cisco router. However, depending on chassis size and a variety of other electromagnetic considerations,
installing the antenna directly on the chassis is not always recommended.
|
1 x SMA(m)
|
2 dBi, 698-960 MHz
2.8 dBi, 1447-1511 MHz
3.7 dBi, 1710-2690 MHz
|
IR1101 with P-LTE cellular module
|