Table Of Contents
Gateway Load Balancing Protocol (GLBP) is now Stateful Switchover (SSO) aware. GLBP can detect when a router is failing over to the secondary Route Processor (RP) and continue in its current GLBP group state.
Prior to being SSO aware, GLBP was not able to detect that a second RP was installed and configured to take over in the event that the primary RP failed. When the primary failed, the GLBP device would stop participating in the GLBP group and, depending on its role, could trigger another router in the group to take over as the active router. With this enhancement, GLBP detects the failover to the secondary RP and no change occurs to the GLBP group. If the secondary RP fails and the primary is still not available, then the GLBP group detects this and re-elects a new active GLBP router.
Configuration information is included in the "Configuring GLBP" module of the Cisco IOS IP Application Services Configuration Guide, Release 12.4T, at the following URL:
The following sections provide information about this feature:
For a complete list of features included in the "Configuring GLBP" module, see the Feature Information Table located toward the end of the module.
Command Reference Information
Command reference information is included in the Cisco IOS IP Application Services Command Reference, Release 12.2SR, at the following URL:
New or Modified Commands
The following commands are new or modified for this feature:
•debug glbp events
List of All Release 12.2SR Commands
An alphabetical list of all Cisco IOS Release 12.2SR commands is in the Cisco IOS Master Commands List, Release 12.2SR, at the following URL:
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2007 Cisco Systems, Inc. All rights reserved.