The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Contents
A - C - E - F - I - M - O - R - S - T - U - V -Index
A
adjusting IPv6 RIP timers, task 1
auto-summary (RIP) command 1C
configuring the maximum numbers of equal-cost paths supported by IPv6 RIP, task 1E
encapsulations
split horizon for Frame Relay and SMDS, RIP 1F
Frame Relay, split horizonSMDS (Switched Multimegabit Data Service)
disabled split horizon 1I
IP
advertising, definition 1
split horizon, enabling and disabling 1
ip rip authentication mode command 1
ip rip triggered command 1
ip split-horizon command 1
ip summary-address rip command 1
IPv6
prefix list operand keywords 1M
MD5 (Message Digest 5) authentication
RIP 1
message URL http
//www.cisco.com/cisco/web/support/index.html 1
metrics
RIP 1O
offset-list command 1
originating a default IPv6 RIP route, task 1R
RIP (Routing Information Protocol)
IP
authentication 1
hop count 1
route summarization 1
source IP address, disabling validation of 1
version, specifying 1
RIP for IPv6
description 1 2
RIP router metric 1
route authentication
RIP 1
Routing Information Protocol (RIP)
IPv6
enabling 1S
secondary addresses
use in Frame Relay and SMDS (example) 1
show ip rip database command 1
split horizon
enabling and disabling 1
summary addresses
entries, checking for 1T
timers basic (RIP) command 1U
UDP (User Datagram Protocol)
using with RIP 1V
validate-update-source command 1