Introduction

This guide describes the Cisco IOS command-line interface (CLI) commands used in Cisco Smart PHY 7200. There are four types of CLI: Fan Control Card (FCC) CLI, Cisco Smart PHY 7200 Line Card CLI, Primary eRPD CLI, and Non-Primary eRPD CLI. See the following table for the details.

CLI Type

How to Access

Example Display

FCC CLI

Connect to the console port on the Fan Control Card.

 
HA-Shelf-FCC#

Line Card CLI

Connect to the console port on the line card.

 
HA-Shelf-Slot-0#

Primary and Non-Primary eRPD CLI

Connect to the console port on the cBR-8 router, and SSH to eRPD

OR

 
Router#show cable rpd
Load for five secs: 3%/0%; one minute: 7%; five minutes: 7%
Time source is user configuration, 15:12:08.534 CST Mon Nov 26 2018

MAC Address IP Address I/F State Role HA Auth Name 
7abd.44f9.0020 92.14.11.16 Te7/1/1 online Pri Act N/A slot0-0 
7abd.44f9.0021 92.14.12.16 Te7/1/2 online Pri Act N/A slot0-1 
7abd.44f9.0022 92.14.13.30 Te7/1/3 online Pri Act N/A slot0-2 
7abd.44f9.0023 92.14.14.30 Te7/1/4 online Pri Act N/A slot0-3 
7abd.44f9.0024 92.14.15.30 Te7/1/5 online Pri Act N/A slot0-4 
7abd.44f9.0025 92.14.16.30 Te7/1/6 online Pri Act N/A slot0-5

Router#ssh -l admin 92.14.11.16
HA-Shelf-eRPD-0/0#

Connect to the console port on the Fan Control Card, then access the eRPD.

 
HA-Shelf-FCC#select erpd slot 0 index 0
HA-Shelf-eRPD-0/0#