bh-erpd-mapping
To configure the Backhaul eRPD mapping, use the bh-erpd-mapping command in global configuration mode. To disable the Backhaul eRPD mapping, use the no form of the command.
bh-erpd-mapping backhaul backhaul_id erpd erpd_id
no bh-erpd-mapping backhaul
Command Default
None.
Command Modes
Global configuration mode (config) (FCC and Primary eRPD)
Command History
Release |
Modification |
---|---|
Cisco Remote PHY Shelf 7200 Software 1.1 |
This command was introduced on the Cisco Remote PHY Shelf 7200. |
Usage Guidelines
Use the bh-erpd-mapping command to configure the mapping between backhaul and eRPD.
Examples
The following example shows how to configure the Backhaul eRPD mapping:
HA-Shelf-FCC# configure terminal
HA-Shelf-FCC(config)# bh-erpd-mapping backhaul 1 erpd 0