PDF(545.6 KB) View with Adobe Reader on a variety of devices
ePub(529.2 KB) View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
Mobi (Kindle)(877.9 KB) View on Kindle device or Kindle app on multiple devices
Updated:August 7, 2017
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
The Cisco ATA 190 Series Analog Telephone Adapters are standards-based communications devices that turn traditional telephone and fax communications devices into IP devices. The adaptors are managed from your network and addresses the need of users that connect to enterprise networks, small offices, or voice-over-IP (VoIP) services from the cloud.
ATA 190 is a Session Initiation Protocol (SIP) device. PLAR is common feature for ATA devices.
PLAR is a feature which sends a call to one preconfigured extension once off-hook, known as hot-dial configuration.
Step 1. Enter the value PT-Hotdial in order to create a new partition.
Step 2. Enter the new Calling Search Space (CSS) value CSS-Hotdial and add Partition PT-Hotdial in CSS-Hotdial, as shown in the image:
Step 3. Create new Translation pattern with blank pattern.
As shown in the image, keep the Called Party Transform Mask as the destination number.
Step 4.To work PLAR/Hotdial configuration you have to create the SIP dial rule.
In Cisco Unified Communications Manager Administration, navigate to Call Routing > Dial Rules > SIP Dial Rules.
Now Add New, under Dial Pattern select 7940_7960_OTHER and click Next, as shown in the image:
Enter a name for the pattern and click save. For example, PLAR, as shown in the image:
As shown in the image, type a description and click on Add Plar and click Save.
Note: Ensure you do not type anything under Value. It has to be empty and under Dial Parameter it has to be Pattern
Step 5. Assign the SIP Dial Rules and CSS on the ATA device.
Assign the CSS on the ATA device (DN - Line CSS)
Assign the SP dial Rule on the device configuration page.
Go off hook on the analog phone connected to the ATA and you should be able to see the destination phone ringing. You should also hear ring back tone on the analog phone.
Check the ATA firmware supported for the PLAR configuration.
Check the ATA device registered and DN send/receive the call.
If still PLAR not working, remove the SIP dial rule from phone configuration page and re-assign the same.