Date and Time Settings on SPA302D Handset

Available Languages

Download Options

  • PDF     (183.1 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (219.9 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (215.6 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:August 16, 2017
Document ID:SMB3995

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Date and Time Settings on SPA302D Handset

Objective

The data and time in SPA302D is synchronized with the SPA232D base. The SPA232D gets the time synchronized from Network Time Protocol (NTP) servers. However, you can also edit it manually if the synchronization is not correct. For example, if NTP is not used on the SPA232D, you will need to manually configure time in SPA232D and check whether it is properly synchronized with all the connected SPA302D handsets.

The objective of this article is to show you how to edit date and time settings manually on SPA302D mobility enhanced handset.

Note: Refer the article entitled Time Settings on SPA232D VoIP ATA for further details on how to configure time on SPA232D base device.

Applicable Device

• SPA302D Handset

Software Version

• v2.31

Tone Settings

 

Step 1. On the home screen, press the Select button to choose the Settings icon. The selection will be highlighted with a black outline as shown in the above image.

 

Step 2. On the Settings menu, choose Date/time with the use of up and down navigation buttons and press the Select button.

 

Step 3. Use left and right navigation buttons to change the value of each field.

Step 4. Press the Save softkey to save the selection.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco