Firepower 7000 Series Appliance Rail Kit Installation Instruction

Available Languages

Updated:May 27, 2016

Document ID:200488

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

Width of Hardware

Front view of a Cisco Firepower 70xx model

Front view of a Cisco Firepower 71xx model

Mini 1U Installed onto 1U Tray

Step 1: Install power adaptors in chassis

Step 2: Install mini 1U systems in chassis

Step 3: Secure mini 1U systems with thumb screws

Post-Rack Installed onto 1U Tray

Step 1: Attach 2-post ear to chassis side wall

Step 2: Install chassis into 2-rack post

Columbus 1U Rack Mount Slide

Step 1: Remove the inner rail from the rail assembly

Step 2: Attach inner rails to chassis sidewall

Step 3: Mount the L-shape bracket onto the outer rail

Step 4: Install outer rail slides to rack post

Step 5: Install chassis into the rack

Introduction

The Cisco Firepower 7000 series hardware platform comes with two different form factors. This document illustrates the steps to install rail kit on a Cisco Firepower 7000 series hardware platform.

Width of Hardware

Within the 7000 series platform, the Firepower 7110 and 7120 devices are 1U appliances. However, the Firepower 7010, 7020, 7030, and 7050 devices are 1U appliances with one-half width of the rack tray.