Introduction
This document describes the procedure to update the shell password of the EPNM server.
Prerequisites
Requirements
Cisco recommends that you know these topics:
- Evolved Programmable Network Manager (EPNM)
- Current shell password
Components Used
The information in this document is based on these software and hardware versions:
- EPNM software version 7.x
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.
Configure
Note: This process requires you to know the current shell password
Configurations
Step 1. Log in to the EPNM CLI as admin:
Step 2. Run the command "shell disable" and enter the current shell password when prompted:
epnm/admin# shell disable
Enter shell access password :
shell access is disabled
epnm/admin#
Step 3. Run the command "shell" and enter the new shell password when prompted:
epnm/admin# shell
Shell access password is not set
Configure password for shell access
Password :
Password Again :
Shell access password is set
Run the command again to enter shell
epnm/admin#
Verify
Run the "shell" command with the updated password to verify if you drop to the Linux shell:
epnm/admin#
epnm/admin# shell
Enter shell access password :
Starting bash shell ...
ade #
ade #