Cisco Nexus 6000 Series NX-OS Unicast Routing Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents
Find Matches in This Book

Results

Updated:
July 1, 2015

Chapter: F Commands

F Commands

This chapter describes the Cisco NX-OS Hot Standby Router Protocol (HSRP) commands that begin with F.

feature hsrp

To enter Hot Standby Router Protocol (HSRP) configuration mode and enable HSRP, use the feature hsrp command. To disable HSRP, use the no form of this command.

feature hsrp

no feature hsrp

 
Syntax Description

The command has no arguments or keywords.

 
Command Default

Disabled

 
Command Modes

Global configuration mode

 
Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.

 
Usage Guidelines

You must enable the HSRP feature before you can configure HSRP.

This command does not require a license.

Examples

This example shows how to enable HSRP on the switch:

switch# configure terminal
switch(config)# feature hsrp
switch(config)#
 

This example shows how to disable HSRP:

switch# configure terminal
switch(config)# no feature hsrp
switch(config)#

 
Related Commands

Command
Description

hsrp group

Creates and activates an HSRP group.

show feature

Displays the status of features on a switch.

show hsrp

Displays HSRP information.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco