S Commands

This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) commands that begin with S.

shutdown (VRRP)

To disable a Virtual Router Redundancy Protocol (VRRP) configuration, use the shutdown command. To enable a VRRP configuration, use the no form of this command.

shutdown

no shutdown

 
Syntax Description

This command has no arguments or keywords.

 
Command Default

Disabled

 
Command Modes

VRRP configuration mode

 
Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.

 
Usage Guidelines

Shut down the virtual router before configuring the virtual router parameters; you can only configure the virtual router after it is in the administrative shut down state. Enter the no shutdown command to update the virtual router state after completing configuration.

Examples

This example shows how to shut down a VRRP group:

switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# no switchport
switch(config-if)# vrrp 45
switch(config-if-vrrp)# shutdown
switch(config-if-vrrp)# address 6.6.6.45
switch(config-if-vrrp)# no shutdown
switch(config-if-vrrp)#

 
Related Commands

Command
Description

feature vrrp

Enables VRRP.

show vrrp

Displays VRRP configuration information.

clear vrrp

Clears all the software counters for the specified virtual router.