F Commands

This chapter describes the Cisco NX-OS Hot Standby Router Protocol (HSRP) commands that begin with F.

feature hsrp

To enter Hot Standby Router Protocol (HSRP) configuration mode and enable HSRP, use the feature hsrp command. To disable HSRP, use the no form of this command.

feature hsrp

no feature hsrp

Syntax Description

The command has no arguments or keywords.

Command Default

Disabled

Command Modes

Global configuration mode

Command History

Release
Modification

5.0(3)N1(1)

This command was introduced.


Usage Guidelines

You must enable the HSRP feature before you can configure HSRP.

Note In Cisco NX-OS Release 5.0(3)N1(1), a software upgrade on the Cisco Nexus 5548 switch and the Cisco Nexus 5596 switch that has the Layer 3 features enabled is disruptive. You must reload the switch and the Cisco Nexus 2000 Series Fabric Extender.

This command does not require a license.

Examples

This example shows how to enable HSRP on the switch: 

switch# configure terminal

switch(config)# feature hsrp

switch(config)#

 
   
 
    
   
 This example shows how to disable HSRP: 
 
    
   
 
    
switch# configure terminal

 
   
 
    
   
 
    
switch(config)# no feature hsrp

 
   
 
    
   
 
    
switch(config)#

 
   
 
    
   
 Related Commands
 
   
 
    
 
      
      
      
 
        
        
 
         Command 
        
 		 
        
        
 
         Description 
        
 		 
      
 
      
 
       
 hsrp group 
 		 
       
 Creates and activates an HSRP group. 
 		 
      
 
      
 
       
 show feature 
 		 
       
 Displays the status of features on a switch. 
 		 
      
 
      
 
       
 show hsrp 
 		 
       
 Displays HSRP information.