Cisco Network Convergence System 1004 Workflow

Available Languages

Updated:September 14, 2020

Cisco NCS 1004 Workflow

The Cisco Network Convergence System (NCS) 1004 is a 2 RU system that delivers fully programmable, high-bandwidth capacity (up to 4.8 Tbps) wavelengths over distances exceeding 3000 km using existing fiber. Powered by the industry-leading Cisco IOS XR operating system, Cisco NCS 1004 offers robust functions such as third party application hosting, machine-to-machine interface, and telemetry.

Overview of NCS 1004 Unpack and Verify NCS 1004 Install NCS 1004 on a Rack Ground NCS 1004 Connect AC Power Connect DC Power Install Components Verify Status of Components		Verify System Setup Configure Card Mode Configure LC Mode Configure Muxponder Mode Configure BPS Configure Controllers � AINS � Laser Squelching � Idle Insertion � LLDP Drop � Loopback � TTI Configure Sub-sea Configure PM Configure L1 Encryption Configure GMPLS UNI Configure Smart Licensing Configure PRBS Configure GCC		Configure Telemetry Replace Components Disaster Recovery Remove Data in Disk
Boot NCS 1004 � Boot Using USB � Boot Using iPXE Boot Using ZTP � Boot Using Golden ISO Verify Boot Operation Configure Management Interface Configure Telnet Configure SSH Configure Clock Create User Profiles Perform System Upgrade Perform Firmware Upgrade Install Packages		Overview Enable Netconf Enable gRPC Configure Slice Configure Optics Controller Configure TTI and Loopback Configure Performance Monitoring Configure Idle Insertion		Alarm Troubleshooting

NCS 1004 Publications

Install Hardware	Install and Upgrade Software	Configure Using CLI	Configure Using Data Models
Troubleshoot	Command Reference	Regulatory Compliance	Release Notes