Introduction
This document describes what actions to take to enable Cisco Unified Call Manager (CUCM) local end-users (not Lightweight Directory Access Protocol (LDAP) synced) to log into Jabber in a Single Sign-On (SSO) enabled cluster.
Applies for Jabber for Windows only.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
- Cisco Unified Communications Manager
- Single Sign-On (SSO)
- Cisco Jabber
- Windows Command Prompt (CMD)
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.
Solution
Previously, the SSO_Enabled Jabber Parameter was available to be used under the Jabber configuration file (jabber-config.xml) to disable the SSO feature for specific users via the Cisco Support Field within the Jabber device configuration under the CUCM, but this parameter has been deprecated since March 2021, refer to the Parameter reference guide for Jabber 12.9.
The only workaround consists of completely disable the SSO feature in the local computer client via the CMD install switch:
msiexec.exe /i CiscoJabberSetup.msi CLEAR=1 SSO_ENABLED=FALSE
Alternatively, the Jabber Bootstrap file (jabber-bootstrap.properties) located in C:\ProgramData\Cisco Systems\Cisco Jabber can be manually modified (line 28) as shown here:
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
SSO_Enabled: FALSE
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
EnableDPIAware: TRUE
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
STARTUP_AUTHENTICATION_REQUIRED: FALSE
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
NOT_SPECIFIED
UXModel: Modern
NOT_SPECIFIED
Verify
There is currently no verification procedure available for this configuration.
Troubleshoot
There is currently no specific troubleshooting information available for this configuration.
Feedback