Safelist/Blocklist limitation and configuration of limits

Available Languages

Updated:November 16, 2016
Document ID:200699

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes the Safelist/Blocklist (SLBL) limitation and configuration of the limits for the Cisco Email Security Appliance (ESA) and Security Management Appliance (SMA).

Safelist/Blocklist limitation and configuration of limits

The size limit of the SLBL can be adjusted through the web interface of the ESA or SMA.

From the ESA: Monitor > Quarantines > End-User Safelist/Blocklist (Spam Quarantine) > Edit Settings

From the SMA: Management Appliance > Centralized Services > Spam Quarantine > End-User Safelist/Blocklist > Edit Settings

Note: Currently, the maximum limit is 500. This is the maximum number of addresses or domains for each list, for each recipient. If you allow a large number of list entries per user, system performance might be adversely affected.

Revision History

Revision Publish Date Comments
1.0
29-Sep-2016
Initial Release
TAC Authored

Contributed by Cisco Engineers

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products