The logout link is disabled by default when using SAML. It is controlled by the idpSLOUrl setting in authentication.conf.
The definition of this setting is documented in Configure SAML SSO using configuration files on Splunk Enterprise

Note: This document is only available for Splunk Enterprise. However, the setting also applies to Splunk Cloud.
This value can be checked using the UI by navigating the the SAML Configuration setting in Splunk Web.
The value can also be checked via command line examination of authentication.conf file and looking for the idpSLOUrl setting. ( The path from this results were set to the example used in the documentation )
splunk@sh-node:~$ splunk btool authentication list --debug | grep idpSLOUrl
/opt/splunk/etc/system/local/authentication.conf idpSLOUrl = https://yourpath/idp/SSO.saml2
Configure basic SSO using SAML with the authentication.conf_file
When the "Single Log Out (SLO) URL" ( idpSLOUrl in authentication.conf ) is not specified the logout button will be unavailable as seen in a typical sso configuration.
To enable the logout link an entry has to be made into the Single Log Out (SLO) URL field under SAML configuration.
Important Note: To allow users to log out of the IdP and Splunk, this value must be set to the IdP's logout protocol/workflow or the user will not be logged out of either the IdP or Splunk. If the Idp's logout protocol/workflow URL is not used, the logout link will appear but when it is pressed, the user will NOT be logged out of the IdP or Splunk.
Configure basic SSO using SAML with the authentication.conf file
| Revision | Publish Date | Comments |
|---|---|---|
1.0 |
28-Sep-2026
|
Initial Release |