How do I install the MultiSite option key?

Available Languages

Updated:April 23, 2015
Document ID:112627

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This article relates to the Cisco TelePresence System Codec C90, Cisco TelePresence System Codec C60, Cisco TelePresence System Codec C40 and Cisco TelePresence System EX90 products.

Q. How do I install the MultiSite option key?

A. This answer is valid for the following products:

TANDBERG EX90

TANDBERG Codec C40

TANDBERG Codec C60

TANDBERG Codec C90

Follow the instructions below to install the MultiSite option key on the TANDBERG Codec:

  1. Log into the system as admin using SSH (Secure Shell)

  2. Execute the following command: xCommand SystemUnit OptionKey Add Key: <enter the key>

  3. Reboot the system.

Related Information

Revision History

Revision Publish Date Comments
1.0
23-Apr-2015
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco