Document ID: 48249
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
activity Command
Codes
Related Information
Introduction
This document explains the codes displayed when the activity command is issued on the Cisco MeetingPlace server.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the Cisco MeetingPlace server software (all versions).
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
activity Command
When you issue the activity command and select 1, the current state of all ports is displayed. There are several two-letter designations that show what the states are.
Codes
Note: Some of these occur only briefly.
|
Code |
Description |
|---|---|
|
-- |
Idle |
|
FA |
Finding Application |
|
TC |
Terminate Call |
|
SC |
Starting Call |
|
CD |
Conference Direct (used for direct inward dial [DID] setups) |
|
PR |
Profile Access (used for DID setups) |
|
MN |
MeetingNotes (used for DID setups) |
|
CA |
Combined Access |
|
CO |
Conference (someone is in a conference) |
|
GO |
GUI Outdial (someone initiated a call from Cisco MeetingTime) |
|
SO |
SIM Outdial (a MAJ/MIN alarm is outdialing) |
Related Information
- Conferencing Software
- Voice Technologies
- Voice, Telephony and Messaging Devices
- Voice Software
- Recommended Reading: Troubleshooting Cisco IP Telephony
- Technical Support - Cisco Systems
| Updated: Jan 31, 2006 | Document ID: 48249 |