Document ID: 15025
Contents
Introduction
Prerequisites
Requirements
Components Used
Conflicts
NetPro Discussion Forums - Featured Conversations
Related Information
Introduction
This document discusses LAN2LAN conflicts with Western Digital Elite 16.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conflicts
The SMC (Western Digital) Elite 16 Ethernet card uses 32 consecutive port address, with the default set to start at 240. The Elite 16 default then uses port addresses 240-25F hex. The LAN²LAN default setting is port address 258H, which uses port address 258-25F hex. This causes both cards to be loaded using ports 258-25F.
In order to eliminate this conflict, reconfigure either the Elite 16 or the LAN²LAN so the port ranges do not overlap; that is, reconfigure to a value other than the default.
NetPro Discussion Forums - Featured Conversations
| NetPro Discussion Forums - Featured Conversations for LAN |
| Network Infrastructure: LAN Routing and Switching |
| Network Infrastructure: Getting Started with LANs |
Related Information
| Updated: Oct 03, 2005 | Document ID: 15025 |