Cisco Small Business Video Surveillance Cameras

Introduction

This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Q. How do I go to the WVC210 web utility after I have changed the port?

A. Complete these steps:

1. To change the alternate port of the camera, go to Setup then Basic. Place a check mark on Enable Alternate Port, enter a Port Number from the range of 1024-65534 and click Apply. A message window comes up and shows: "Changing the Alternate port number also changes the WAN port on the DDNS screen". Click OK and press Apply.

   Figure 1

   

   Figure 2

   

2. Click OK to close the Windows Internet Explorer.

3. To open the camera's Web UI locally, follow this format: http://LAN IP address:alternate_port.

   

   Note: If you wish to access the camera over the Internet, port forwarding needs to be configured on the router.

   

   Follow this format to access the camera remotely: http://WAN IP address:alternate_port.

   

Related Information

• Technical Support & Documentation - Cisco Systems