ATM Switch Router Command Reference, 12.0(13)W5(19) through 12.0(22)W5(25) - O Commands [Cisco Catalyst 8500 Series Multiservice Switch Routers]

O Commands

The commands shown in this chapter apply to the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. Where an entire command or certain attributes of a command have values specific to a particular switch or switch router, an exception is indicated by the following callouts:

Catalyst 8540 MSR
Catalyst 8510 MSR and LightStream 1010

Note Commands that are identical to those documented in the Cisco IOS software documentation have been removed from this chapter.

Note Commands that no longer function as expected in ATM environments have also been removed from this chapter.

Refer to Appendix D of this command reference for a detailed list of commands that have been removed, changed or replaced.

outgoing-port

To filter ATM signalling call failure based on the outgoing interface rejected call, use the outgoing-port ATM signalling diagnostics configuration command. To return the outgoing port to the default, use the no form of this command.

outgoing-port [atm card/subcard/port]

no outgoing-port

Syntax Description

card/subcard/port

Specifies the card, subcard, and port of the ATM interface. The card number is displayed using the show interfaces command.The subcard number can be either 0 or 1.

Defaults

Command Modes

ATM signalling diagnostics configuration

Command History

Release	Modification
11.2(8.0.1)	New command

Usage Guidelines

The default 0 means the incoming interface is not considered during filtering.

Examples

The following example shows the outgoing-port command.

 Switch# configure terminal

 Switch(config)# outgoing-port ATM 0/1/1

Table of Contents

O Commands

outgoing-port