Guest

Cisco 7600 Series Routers

Cisco IOS Software Release 12.2(18)SXD Q&A

Table Of Contents

CISCO IOS SOFTWARE RELEASE 12.2(18)SXD

CISCO IOS SOFTWARE RELEASE 12.2S

CISCO IOS SOFTWARE RELEASE 12.2SX

NUMBERING

RELEASE 12.2(18)SXD

GENERAL CISCO IOS SOFTWARE QUESTIONS

ADDITIONAL INFORMATION


Q & A

CISCO IOS SOFTWARE RELEASE 12.2(18)SXD


CISCO IOS SOFTWARE RELEASE 12.2S

Q. What is Cisco IOS Software Release 12.2S?

A. Cisco IOS® Software Release 12.2S is designed for Enterprise campus and Service Provider edge networks that require world-class IP and Multiprotocol Label Switching (MPLS) services. The Cisco Catalyst® Switches and high-end routers in Release 12.2S provide secure, converged network services in the most demanding Enterprise and Service Provider environments, from the wiring closet and data center to the WAN edge.

Release 12.2S incorporates a series of Cisco IOS Software releases that integrate the proven, mature code base of Major Release 12.2 with critical software features and hardware support from Releases 12.1E and 12.0S.

For more information about Release 12.2S, please visit:

http://www.cisco.com/go/release122s/

Q. What features and hardware support are delivered in Release 12.2S?

A. The infrastructure innovation and technology leadership in Release 12.2S enable advanced Ethernet LAN switching, Metro Ethernet, and Broadband Aggregation services through enhancements in High Availability, Security, MPLS, VPNs, and IP Routing and Services.

High-end hardware support in the Release 12.2S family initially includes the Cisco 7200, 7300, 7400, 7500, and 7600 Series Routers, and the Cisco Catalyst® 2970, 3560, 3750, 4500, and 6500 Series Switches. Support is also planned for the Cisco 10000 Series Internet Router.

Q. Which releases of Release 12.2S are currently available?

A. You can currently download Releases 12.2(22)S, 12.2(20)S, 12.2(18)S, and 12.2(14)S from Software Center:

http://www.cisco.com/public/sw-center/sw-ios.shtml

For detailed information about the new hardware and features supported in each of these releases, refer to the Release 12.2S Release Notes:

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1838/prod_release_notes_list.html

CISCO IOS SOFTWARE RELEASE 12.2SX

Q. What is Cisco IOS Software Release 12.2SX?

A. Derived from Release 12.2(14)S, Release 12.2SX provides Release 12.2S functionality and new features and hardware support for the Cisco Catalyst 6500 Series Switch and Cisco 7600 Series Router.

Q. What features and hardware support are delivered in Release 12.2SX?

A. All new features and hardware support for the Cisco Catalyst 6500 Series Switch and Cisco 7600 Series Router are delivered in Release 12.2SX.

Cisco IOS Software Release 12.1E is in maintenance mode and will not receive new features or hardware support; therefore, Release 12.2SX is the migration path for Release 12.1E customers who run the Cisco Catalyst 6500 Series Switch and Cisco 7600 Series Router.

Q. Which releases of Release 12.2SX are currently available?

A. Customers can currently download Releases 12.2(18)SXD, 12.2(17d)SXB, 12.2(17b)SXA, 12.2(17a)SX, and 12.2(14)SX from Software Center:

http://www.cisco.com/public/sw-center/sw-ios.shtml

For detailed information about the new features and hardware supported in each of these releases, refer to:

Release 12.2SX Release Notes:

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_note09186a00801c8339.html

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_note09186a008019e1e9.html

Release 12.2SX Product Bulletins:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/prod_bulletins_list.html

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletins_list.html

NUMBERING

Q. Why does Release 12.2SX numbering differ from Release 12.2S numbering?

A. Release 12.2SX is derived from, and bases its numbering on, the Release 12.2S code base. Release 12.2S bases its numbering on the mature code base of Major Release 12.2.

Because of these code base dependencies, as well as other factors, Release 12.2SX numbering differs from Release 12.2S numbering.

Q. How will Cisco number subsequent releases of Release 12.2SX?

A. Given that Release 12.2SX numbering depends on Release 12.2S numbering, Release 12.2SX numbering is announced immediately prior to release introduction.

RELEASE 12.2(18)SXD

Q. What is Release 12.2(18)SXD?

A. Release 12.2(18)SXD extends the benefits of Cisco IOS High Availability to Enterprise campus, data center, and WAN aggregation networks, and Service Provider edge aggregation networks that run the Cisco Catalyst 6500 Series Switch and Cisco 7600 Series Router. These enhancements provide nonstop application availability for Enterprise business-critical services, including supply-chain management, secure transactions, IP communications, and e-business. They also provide the network resiliency that Service Providers need to extend revenue through robust Service Level Agreements. This increased availability and resiliency reduces the total cost of ownership for Enterprise and Service Provider networks while also improving their overall productivity and efficiency.

Q. What new features and hardware support are delivered in Release 12.2(18)SXD?

A. Cisco Nonstop Forwarding (NSF) with Stateful Switchover (SSO) delivers seamless Supervisor Engine switchover and nonstop application availability for business-critical services on the Cisco Catalyst 6500 Series Switch and Cisco 7600 Series Router. During a switchover, Cisco SSO provides zero interruption of Layer 2 connections, while Cisco NSF forwards Layer 3 packets continuously with minimal or no packet loss. The continuous packet forwarding enables peering relationships to re-establish without the need for network-wide routing protocol reconvergence.

Gateway Load Balancing Protocol (GLBP) uses network bandwidth more effectively by load-sharing packets over all available paths while protecting the first hop router. Previously, if there was a failure in the primary router or path, first hop redundancy features could only forward packets over the backup WAN paths. GLBP makes it possible for any router in a group to serve as a backup, and simplifies configuration.

MPLS Traffic Engineering Fast Reroute1 provides carrier-class traffic protection and restoration, similar to SONET/SDH. Service Providers can now reroute MPLS label switched paths around any link or node failure with full traffic recovery rates as fast as 50 milliseconds.

Control Plane Policing1 protects the control and management planes of a networking device against malicious Denial of Service attacks, allowing businesses to maintain productivity without interruption. It does so by employing user-defined Quality of Service policies that limit the number of packets destined for both planes.

The Cisco Catalyst 6500 Series Wireless LAN Services Module, part of the Cisco Catalyst 6500 Series of multilayer switches and a key component of the Cisco Structured Wireless-Aware Network framework, is the industry's only enterprise class wireless and wireline switching system, enabling secure, highly available, and easily managed unified networking deployments for Enterprises, midsize businesses, universities, and Service Providers.

GENERAL CISCO IOS SOFTWARE QUESTIONS

Q. Where can I download Release 12.2S?

A. You can download Release 12.2S from Software Center:

http://www.cisco.com/public/sw-center/sw-ios.shtml

You will need an active SMARTnet contract or purchased feature license in order to access and download the release.

Software Center also provides valuable Cisco IOS Software information, including hardware/software compatibility and ordering procedures.

Q. What are release notes?

A. Release notes describe memory requirements, hardware support, software image deferrals, caveats, and changes to the microcode or modem code, and related information. It is highly recommended that customers read the release notes prior to deploying a new Cisco IOS Software release.

Release notes include a list of software image deferrals, which refer to those Cisco IOS Software images not available to customers due to existing software or hardware issues.

Release 12.2SX release notes:

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_note09186a00801c8339.html

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_note09186a008019e1e9.html

Q. What are caveats?

A. Caveats describe unexpected behavior (ie: software defects) in Cisco IOS Software releases. The Release 12.2S and Release 12.2SX release notes include a list of resolved caveats from the most recent maintenance release, as well as a list of open caveats and any applicable workarounds.

ADDITIONAL INFORMATION

Q. Where can I find detailed descriptions of the features and hardware support in each release of the Release 12.2S family?

A. Release 12.2S New Features and Hardware Support, Product Bulletin No. 2216

http://www.cisco.com/en/US/products/sw/iosswrel/ps1838/prod_bulletin09186a0080212b1b.html

Release 12.2SX Product Bulletins:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/prod_bulletins_list.html

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletins_list.html

Q. Where can I find additional information and collateral about the Release 12.2S family?

A. http://www.cisco.com/go/release122s/

1 Support is planned for a future update of Release 12.2(18)SXD