Document ID: 47884
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document provides a sample configuration for connecting a CPA 75x bridge to a CPA 75x IP router using Point-to-Point Protocol (PPP) Challenge Handshake Authentication Protocol (CHAP) and OPX networks.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the CPA 75x bridge and IP router.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Configure
In this section, you are presented with the information to configure the features described in this document.
Note: To find additional information on the commands used in this document, use the Command Lookup Tool (registered customers only) .
Network Diagram
This document uses this network setup:
Configurations
For the configurations used, please refer to the network diagram above.
Verify
There is currently no verification procedure available for this configuration.
Troubleshoot
There is currently no specific troubleshooting information available for this configuration.
Related Information
| Updated: Jan 25, 2008 | Document ID: 47884 |