- Preface
- Chapter 1, Introduction
- Chapter 2, Virtual Appliance Licensing
- Chapter 3. Installing the MSE Virtual Appliance
- Chapter 4, MSE Virtual Appliance on XenServer
- Chapter 5, MSE Virtual Appliance on Hyper-V Platform
- Appendix A, Virtual Machine Setup and Administration
- Appendix B, Command Reference
Cisco MSE Virtual Appliance Installation and Configuration Guide, Release 7.6
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- July 22, 2014
Chapter: Chapter 1, Introduction
Introduction
The Mobility Services Engine (MSE) is offered as a virtual appliance to support lower-end, standard, and high end deployments.
The MSE virtual appliance uses the following standard templates:
- Open Virtualization Format (OVF) for VMware
- Virtual Hard Disk (VHD) for Microsoft Hyper-V
- Open Virtualization Format (OVF) for Citrix XenServer
This chapter describes the system requirements for the MSE virtual appliance and provides general deployment guidelines.
MSE Virtual Appliance Reference Hardware Configurations
The below table lists the available MSE virtual appliance reference hardware configurations:
Resource Management
Resource management depends on the license that you want to deploy. The below table lists the different levels at which you can configure the virtual appliance and which virtual appliance (OVA) that you procure.
|
|
|
|
|||
|---|---|---|---|---|---|
Feedback