CLI Setup Wizard
To use the Setup Wizard from CLI, you must connect to the console port of the Access Point. The default parameters for the console ports are 9600 baud, eight data bits, one stop bit, and no parity. The console ports do not support hardware flow control.
After connecting to the console port on the Access Point, power up the Access Point. After a few minutes, Access Point will start the Controller.
To configure the Mobility Express controller, follow the steps as shown in the example below:
System Name [Cisco_2c:3a:40] (31 characters max): me-wlc Enter Country Code list (enter 'help' for a list of countries) [US]: Configure a NTP server now? [YES][no]: no Configure the system time now? [YES][no]: no Note! Default NTP servers will be used Management Interface IP Address: 220.127.116.11 Management Interface Netmask: 255.255.255.0 Management Interface Default Router: 18.104.22.168 Cleaning up Provisioning SSID Create Management DHCP Scope? [yes][NO]: yes DHCP Network : 22.214.171.124 DHCP Netmask : 255.255.255.0 Router IP: 126.96.36.199 Start DHCP IP address: 188.8.131.52 Stop DHCP IP address: 184.108.40.206 DomainName : DNS Server : [OPENDNS][user DNS] Create Employee Network? [YES][no]: YES Employee Network Name (SSID)?: WestAutoBody-Employee Employee VLAN Identifier? [MGMT][1-4095]: MGMT Employee Network Security? [PSK][enterprise]: PSK Employee PSK Passphrase (8-38 characters)?: Cisco123 Re-enter Employee PSK Passphrase: Cisco123 Create Guest Network? [yes][NO]: YES Guest Network Name (SSID)?: WestAutoBody-Guest Guest VLAN Identifier? [EMPLOYEE][1-4095]: EMPLOYEE Guest Network Security? [WEB-CONSENT][psk]: WEB-CONSENT Create Guest DHCP Scope? [yes][NO]: NO Enable RF Parameter Optimization? [YES][no]: YES Client Density [TYPICAL][Low][High]: TYPICAL Traffic with Voice [NO][Yes]: Yes Configuration correct? If yes, system will save it and reset. [yes][NO]: yes Cleaning up Provisioning SSID
The Access Point will reboot and after it comes back up, login to the Mobility Express controller WebUI from the browser using https://<mangement_ip_address> Cisco Mobility Express controller uses a self-signed certificate for HTTPS. Therefore, all browsers display a warning message and asks whether you wish to proceed with an exception or not when the certificate is presented to the browser. Accept the risk and proceed to access the Mobility Express Wireless LAN Controller login page.